Rejuvenation.
Flashes of pulsed light reduce the effects of ageing skin. The treatment stimulates collagen production, modifies connective tissue, tightens dilated pores, improves skin elasticy and reduces fine lines. The skin tone improves, pores are tightened and color increases. The tolerance for this treatment has proven to be excellent.
Care duration : 3 or 5 sessions are necessary at interval of 1 to 2 weeks.
SR : 535 – 1200 nm
Hair Removal Light Skin.
Pulsed light is absorbed by melanin (a colored pigment) present in hair during the growth stage (anagenphase), and is then conducted down to the root of the hair. This light is turned into heat, and it is the heat that destroys the follicle and the root, without side effects. This is called “selective photothermolysis” or “photodepilation.” Excellent results, 80% of hair removed after the third session.
Care duration: 8 to 12 sessions are required at interval of approximately six weeks.
HR: 620 - 1200 nm for light skin
Hair Removal Dark Skin
The use of a specific filter (DS 690 nm) makes it possible to safely perform treatments on dark skin. The specific filtration for dark skin promotes the absorption of the pulsed light by the melanin, and thus a high level of efficiency. The obtained results are very satisfactory. Care duration: 8 to 12 sessions are required at interval of approximately six weeks.
DS: 690 - 1200 nm for dark skin
TECHNIQUES
Comfortable, fast & efficient treatments thanks to the water cooling system
Water cooling for endurance and an exceptionally long life Even at maximum power, the medical device can work for hours without overheating of the lamp or crystal. This is due to the continuous cooling of the lamp and filter, and the absorption of the infrared rays by the water. The stainless steel radiator facilitates a rapid and efficacious cooling of the lamp.
Optimal effectiveness through a power up to 80 J/cm² at cartridge level To achieve optimal results, maximum power is needed for the treatment process: 60 J per cm², meaning more than 300 Joules per flash at lamp level. This leads to max 30 Joules per cm² at the level of the crystal.
Communicating powerful, efficient and effective systems
A balanced train of pulses for more security
To avoid risk of burning or discomfort caused by a single flash or a too long flash, all emitted flashes are cut into several pulses. Each pulse raises the target temperature, while the intervals between pulses allow the skin to dissipate the heat.
Balanced pulses for more comfort
Balance of pulses permits to get the same density of energy from the first until the last pulse by widening the duration of each pulse. This balance of train of pulse allows an efficient treatment of difficult skin conditions.
A “simmer” for powerful and effective “square” pulses
The “simmer” enables the lamp to be powered up before the flash. The energy level needed is therefore reached more quickly and efficiently than with other pulsed light systems. With the simmer in use, the pulse comes in a “square” shape.
Connector for the hand piece
The new front connection facilitates simplified maintenance and easy replacement of the handpiece.
DI filter
With the deionization filter, the new generation of DERMEO pulsed light devices offers optimalized water filtration, which significantly improves the quality of the water, and, therefore, the quality of the flash.
LCD color touch screen
STFLASH 4 has a resistive 5.7 inches color touch screen, which provides the user with excellent legibility and comfort, even when wearing gloves. Featuring new, more ergonomic and intuitive software to facilitate comfortable daily use.
Evolutive software for easy updating
The software is embedded on an SD card, facilitating a quick and easy update of the medical systems via internet.
A user profil manager for a controlled delegation
The system can manage up to 5 different users. The administrator can, in detail, control the rights per user, meaning access to certain applications may be prohibited or restricted.
A logbook which allows access to complete information
At any time, access the number of flashes made per transaction, and view the date and time of carried out treatments.
Remote access
The user has the ability to remotely monitor the use of the system through optional networking software
TECHNOLOGY
Easier, faster, more functional
Interchangeable EASYLAMP® LAMP CARTRIDGE
Worldwide innovation: DERMEO has developed the first watercooled LAMP CARTRIDGE which is directly interchangeable by the user. When the lamp has to be changed, there is no need to send it back to the workshop or to contact a technician.
Patent Filed
In a few seconds, the lamp can easily and safely be replaced.
The replacement of the LAMP CARTRIDGE is simultaneously
and without extra cost accompanied by the complete
replacement of the cartridge containing the lamp, the optical
cavity, reflectors, anti-UV filter and embedded electronics.
Interchangeable optical guides
To ensure optimal effectiveness of the treatments, DERMEO has created two different sizes for the optical guides, 2.25 cm² and 8.25 cm². This allows the operators to use up to 4 different filtrations.
The use of optical guides enables the operator to cover a large treatment area. The benefit obtained by the covered surface is materialized by a gain of flashes and time. Below it can be seen that two flashes are sufficient to treat an area of 28 mm, whereas with most competing devices, four flashes are required. Also, a large treatment area facilitates greater profitability.
Benefits reflective filters
A filter is composed of several layers laid on a light guide made of quartz. The reflective filters allow multiband selective filtrations, and, therefore, the wavelengths are exactly adapted to the absorption peaks of the targeted chromophores. The non sampled energy of the ray of light is reflected back into the lamp where the heat is dissipated by the water cooling system. Results: No heating at the quartz and at the skin level.
Absorption curve of chromophores by level of wavelenght Depth of the penetration of the light depending on the selected wavelenght
Evolutionary technology
DERMEO is in constant development and recruits only the best engineers in mechanics, electronics, energy conversion, computer software development, optics, and composite materials, which has enabled DERMEO to be awarded several patents.
Quality
DERMEO provides you with the knowledge of an ISO 9001 and ISO 13485 certified expert. Compliance with these international and medical organizational standards is a guarantee of quality for both our customers and our suppliers.
Medical research
Clinical research investments are made in partnership with groups of specialist doctors to assess the performance, security, and innocuousness of the devices that are on the market.
New range compact and easily transportable
Compact and lightweight
Thanks to the miniaturization of components, the new range of pulsed light system is lighter and more compact, offers exciting new treatment possibilities (ability to perform treatments at home).
The LTFLASH, easily transportable, is an outcome of focused technology to obtain a high-quality and professional result.
INOVATION
DHR technology :
Dynamic Hair Removal
This new technology makes it possible to provide care to the treated area by scanning it. It delivers a gradually increase of the temperature at the target’s chromophore area. This program is particularly suitable for hair removal on light and dark skin.
In DHR mode, the LTFLASH device is able of delivering a maximum pulse repetition frequency of 7 pulses per second (7Hz). This technology reduces the treatment timefor the operator, and, due to a softer flash, raises the level of comfort for the customer.
MARKETING, SALES & INTERNATIONAL APPROVALS
Sales arguments DERMEO provides its users with relevant marketing material, such as a list with unique selling points and a list containing frequently asked questions with appropriate answers, which can be used when interacting with patients that are interested in treatments by DERMEO’s devices.
Training The training program is supported by 2 volumes of training manuals. One is theoretically and technically oriented, whereas the other volume focuses on the practical and commercial aspects.
Media exposure DERMEO’s products and treatments receive a strong national and international exposure in on and offline media.
Clinical and legal To provide better information to patients and better protection to practitioners, models of quote / informed consent / medical history forms, which have been validated and approved by doctors and lawyers, are available for the users.
International medical approvals
DERMEO medical devices are compliant with international standards.
DERMEO has passed electromagnetic compatibility and electrical compliance testing. STFLASH 4 is approved by the Health Ministries of several countries including the United States of America, Australia, and is pending by the Health Ministries of Canada, Mexico, Kowait and Saudi Arabia (updating in progress).